How To Use Scraper Winch?

Generally we will scraper winch sales to users, will tell them, need to see the inside of the instructions, how to fuel, how to maintain, but the actual few people to do according to our requirements, some even harrow winch instructions have not seen. We visited several mining areas and found that workers were not paying attention when using electric rakes:

1, the steel wire rope wear degree, we found that many workers in use, the steel wire rope with hair, have not replaced the steel wire rope, in the visit we also directly encountered the steel wire rope break, fortunately no accident. Also do not know is the worker did not report or construction team in order to save the wire rope money, here I remind the general construction, do not cause greater losses in order to save that money.

2, guide wheel have been worn in the same position, use for a long time we will find that guide wheel wear out quickly, but we use opportunely scraper mine winch, the guide wheel will very rhythmic to wear change, first or wire rope, wire rope to preview, reduce friction, so there is a time when we in the operation of the wire rope can be in the position of the guide wheel to move a little, so avoid friction in the same place every time lead to guide wheel soon need replacing.

3, refueling, basically every time found that people with machinery know the need for refueling, may be the previous lack of oil caused equipment damage is afraid, but your home oil is also money to buy ah, refueling can not add too much, add too much will lead to the leakage of gear oil, if more will lead to braking slip, no way to control. Therefore refueling is also learned, can not be more, can not be less. Add the right amount. We can refer to the oil level line in the reduction gear once, after every time pay attention to add with the container will not add wrong, and remember to regularly change the gear oil. We'll see a little hole in the top of the ring, and that hole is where we're going to add the butter, so we can use the butter gun to get the butter in.

4. When the brake belt is worn to the iron plate, it needs to be replaced. Do not use the brake to save money before replacing, which will wear the gear ring.

5, the scraper winch to be fixed, find a stable position to fix, to avoid gear oil with the motor tooth leakage out of the other end.

As long as we pay attention to the above points in the use, and do the above points, then our scraper winch service life will increase. Good luck with your equipment.